I posted some pics in my gallery at oldspower.com
http://www.oldspower.com/photopost/show ... puser=2995
basically, there is bondo covering from about an inch back from the front leading edge to aboult 5 or 6 inches back. It leaks rain water, so I know the rust goes through there. Also, there are some holes that go all the way through on both sides where the seams in the vinyl were located.
I don't own a welder, but was thinking of buying an oxy/acet. set up from harbor freight so I could weld , heat, & cut when needed.
My other alternative is to use that new epoxy for autobody. Any opinions about that?