It is currently Sat Oct 20, 2018 2:29 pm

All times are UTC - 5 hours





 Page 1 of 1 [ 1 post ] 
Author Message
PostPosted: Wed Jun 11, 2003 6:09 pm 
TOC Admin
TOC Admin
User avatar

Joined: Fri Jun 06, 2003 3:58 pm
Posts: 3165
Images: 29
Location: Michigan, USA
Underpowering a speaker is likely to damage the voice coil due to the excess heat created by distortion. This distortion, called clipping, is created when the amp is not able to supply the power demand when the volume is turned up. If you turn the volume up very high without the power to back it up, you'll end up clipping the signal coming out of the amp. The speaker will try to reproduce this clipped signal, and if played under these circumstances for any length of time, the speaker will not last very long.

There is a mis-conception that if you're not giving the speaker as much power as it can handle you won't blow it, but that simply is not the case. The only way to really address this problem is to replace your speaker for one with a lower power rating, and a higher SPL rating, or replace your amp with one that better matches the speaker's power handling capability. An alternative to replacing the equipment is to simply keep your volume turned down!

Make certain that power and ground wiring for the amplifier is sufficient to deliver adequate current to the amp. Proper wire gauge and clean connections are critical for strong performance.



_________________
1999 Oldsmobile Intrigue GLS
1987 Oldsmobile Delta 88 Royale
ImageImage
Offline
 Profile Personal album  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 1 post ] 


All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  

cron