Hey guys, decided to put a transmission into my 200 dollar car, and either keep it around, or sell it. The car is far too good of shape to just part out.

I need to get as much information together as possible before the swap. I found a used trans with warranty for $400. I have done a FWD manual transmission R&R on my ford probe once, but have never done an Automatic. Anything I should be aware of before I start on my project?

Brando, does Alldata have a step by step R&R for the trans in this car? 3800 engine.

This is going to be fun, unlike every other major job I've done. Usually I am doing the job because its my daily driver, and I am in a rush to get it back on the road. This car, I dont care if it takes a year. I am sure it wont.

Aaron, it sounds pretty exciting what you're doing. Are there any future plans to install any trick "gadgets" (i.e., another car computer.)?

Does that car have the OBDII connector?

MysterHK,

Havent thought that far ahead, but maybe I should... The car has the old style ALDL communication, which is good - I can interface with it much easier. I am not even sure if I want to keep the car, or sell it.

If my wife would decide to get her license, I would definately keep it. It would be a perfect car for her to get the baby around in. But on the same note, the extra $$$ would be helpful!

Hi 88delta88, hello everyone,


Auto will be heavier than a stick and you'll be dealing with a TC instead of a clutch. Other than that, there should be little difference.

Norm

Excellent, I think it will be a smooth procedure. Lots of room under the hood to work.