Electrical Problem 23

pstrack · **Joined:** Fri May 04, 2007 12:56 pm **Posts:** 3

i have an electrical problem 23 come up on my digital dash then the das goes blank, how can I fix this?

88delta88 · Posted: Fri May 04, 2007 2:00 pm

Where does it show "23" on your dash? Do you think this could be the error code, or just a glitch related to the problem? When does it display this, and for how long until it goes blank?

pstrack · **Joined:** Fri May 04, 2007 12:56 pm **Posts:** 3

the electrical problem 23 shows on the digital dash and then the dash goes blank only to say electrical problem...the dash will show for about 2-3 seconds then go off...all fuses appear to be good....

Brando · Posted: Sun May 06, 2007 11:43 pm

When you say digital dash, do you mean the instrument panel cluster, or the...not sure what the proper term is, but the computer/radio/hvac thingy mabobber?

TOC Admin
Brando

pstrack · **Joined:** Fri May 04, 2007 12:56 pm **Posts:** 3

It shows the problem 23 just below where the speed would show on the odometer/speedometer/coolant instrument panel.....would or could it be a bad ground on the battery...I have seen in the past that the plastic piece that binds the 3 grounds to the negative terminal has corroded and lead to possible problems, could this be a part of my problem? It appears clean but that plastic piece that binds the 3 cables is fun to strip off....

Brando · Posted: Tue May 15, 2007 7:48 pm

Sorry it took so long to get back to you...

I can't find any specifics on that code...but here is what I did find:

Quote:

NO CLUSTER DISPLAY

A loss of Instrument Panel Cluster (IPC) display and messages can result from the following:

* Loss of 12-volt power to IPC.
* Loss of ground to the IPC
* Loss of 7-volt power to IPC.
* Ground in 7-volt circuit No. 807 (Purple/White wire) anywhere along its length.
* Internal BCM or IPC fault.

So the ground is very much a possibility and I would check that if you haven't already.

TOC Admin
Brando

Electrical Problem 23

Who is online