nalc wrote:
My CO was at 3.3%, pass was 0.7%
My hydrocarbons were at 187 parts, pass was 128 ........
Not what I was looking for. I can assume, that they did not tell you the nature of the problem. IE: a faulty CAT, sensor, ignition, contaminated oil, or a fuel delivery problem.
From the numbers given, I suspect a vacuum leak.
Quote:
........ The stock muffler rusted out before ........
If the muffler was replaced with an OEM type, it would still be a stock system, and it would not be a factor.
No need to replace the CAT, unless it has been proven to be defective.
Quote:
........ The only parts still stock (as far as I know), are the headers, crossover pipe, and cat ........
I'm assuming you mean manifolds, not headers, because of your reference to the crossover pipe.
Rust is not a factor, unless it's serious enough to cause exhaust leaks, which are another cause for failure.
Quote:
........ Do I need any special tools to adjust it?
If you mean the carb, the FSM will tell you what tools you will need, along with giving you the instructions needed for an accurate adjustment. If it has not been molested in any way, odds are, it does not need adjustment.
Beware: If those instructions are not followed to the letter (exactly) it will fail the test.
andrewk wrote:
I would start with a full engine tuneup ........
Including replacement of the the air and fuel filters, and don't forget the the oil/filter change.
Norm
_________________
Harry S. Truman wrote:
When you have an efficient government, you have a dictatorship.