It is currently Wed Dec 19, 2018 10:50 am

All times are UTC - 5 hours





 Page 1 of 1 [ 1 post ] 
Author Message
PostPosted: Sun Oct 02, 2016 10:51 pm 
TOC Member
TOC Member

Joined: Sun Oct 02, 2016 10:28 pm
Posts: 2
Does anyone know where I can get the suction manifold that is inside the power steering reservoir? It is made of cast metal. I tried to repair it using JB weld but weld failed. FYI it is for a 1957 Super 88, 371 c.i. engine that has the older style can reservoir sitting on top of the power steering pump. The pump is good so I was hoping I did to have to buy a new pump. Or has anyone tried it with out the manifold. I am guessing the manifold helps reduce the turbulence that could be generated in the pump reservoir. last, I thought I would replace the reservoir cap seal. It appeared to have a hardened sealed in the cap, and looks like it is a cork seal. Can anyone confirm this?


Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 1 post ] 


All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  

cron