Well, if the original cat is welded in, you will have to cut it out. Can you weld? If so, that would be easier than using a hacksaw. I am betting you can't weld (like me) so you have to do it the old fashioned way. First, make sure the new cat has the correct inlet and outlet size to fit OVER the exhaust pipe in the car and that it is the correct length as well. Use some good safety stands, if you don't have any, don't do it in the driveway. You might have access to a lift, if so, no problem. At any rate, use safety goggles if you are going to hacksaw the old cat out, metal filings in the ol' eyeball suck

Be ready for some tired arms, because it will take some time, if you have a power saw all the better. Use some bailing wire on the front and back pipes to hold them up when you cut out the cat. When the old one is out, put the new one in, use some new clamps (they probably come with the cat), and clamp those suckers down tight, but before you tighten them, snug them and make sure everything fits well and the cat is parrallel with the bottom of the car and won't jiggle or bump up against the floor pan when you hit bumps in the road. Then tighten everything up real tight and there ya' go. Good luck.