umm.. so im gonna proely finish the intake today or tommorow..but i want to get a heatbarrier going...any ideas. was thinking about a piece or sheet metal about 12 inches long..going up from my frame i guess it will be called :p and up partially around the cone...

wouldn't a big piece of metal block airflow more than it blocks heat???

no because my air comes from under and beside my headlights..i was just gonna put a sheet of metal between it and the rad

i sorta had a brain storm...now i have a 22inch by 12 inch piece of sheet metal...which is gonna be the start of my casing...any ideas now on how to support the intake tube..its a bit heavy...so i want to support it...it some how falling off or wiggling around wouldnt be too good...ideas?

get a bracket from the hardware store in the plumbing section... $1.

a bracket you say? well what type of bracket..you people and your "plumbing section" well i will go look tommorow again..been there like 3 times in the last 2 days..wonderful record eh :d

use the support bracket from your stock airbox. If you look in my engine bay pic, you'll see what holds up mine. I just used a strap around the tube and around the bracket. Maybe that'll help?

they have support brackets for pvc piping, i'd be surprised if any hardware store didn't have some...

well its on..sounds mega shhhweet..pics in a couple minutes..cause the car is outside and im upstairs

m@d tyt3 intake yo!

That looks awesome man!!! I bet it DOES sound sweet! But... that can't be 3" exhaust, its gotta be 2.5".... Nonethe less, it looks awesome!

nope i think its 3....the filter is a 3 inch diameter...on the clamp