Justin, just because you're not pressing on the brake doesn't mean it couldn't be the brakes themselves. As OldsGuy said, when a wheel bearing or hub assembly begins going bad, it makes more of a drumming or grinding sound, usually more noticeable when turning one direction or another. Squeaking is generally associated with brakes, and the "squeakers" built into the brake pads will often squeak when the brakes are not applied, then will quiet down when the brakes are depressed. In many cases the brakes will squeak if the wheel is turned, usually caused by flex in the brake rotor or the pads squeaking against a rust lip on the edge of the brake rotor. Pull the front wheels and be certain before you blindly go into replacing a hub assembly, just to be sure. Also, in regards to installing the hub assembly yourself, it can be done, although you'll need a spindle nut socket, 1/2" drive torque wrench which can go up to 125-150 ft. lbs, as the axle nut needs to be properly torqued after the hub is installed and the axle nut screwed on, possibly some torx or allen wrenches or sockets depending on the style bolts holding the caliper and caliper mounting bracket, wrenches and/or sockets in the appropriate sizes, and possibly a hammer and chisel to separate the hub assembly from the spindle.
_________________
Shawn's Auto Repair and Performance, SW Wis.
www.shawnsautorepair.procarcarezone.com
69 Olds Cutlass S
70 Olds Vista Cruiser Wagon
72 Olds Cutlass S, 12:1 470 stroker, JM40 solid lifter cam, TH400, 3500 10" PTC stall, 4.11 posi
74 442 455/TH350
79 Cutlass 455/TH375 sleeper
'97 GMC Sierra Ext Cab 9" lift w/ 37's