It is currently Mon Nov 16, 2026 4:48 am

All times are UTC - 5 hours





 Page 2 of 4 [ 46 posts ]  Go to page Previous  1, 2, 3, 4  Next
Author Message
 Post subject:
PostPosted: Thu Feb 24, 2005 9:45 am 
TOC Village Idiot
TOC Village Idiot
User avatar

Joined: Mon Jun 09, 2003 5:06 pm
Posts: 2415
Images: 40
Location: Canada
make sure the ignition gives off 12V where it should when you turn the key to ON. This is likely the problem, check ALL of your fuses! The one fuse I'm thinking in particular is the ECM fuse. This would defiantely cause a total and instant dead car as you describe!



_________________
"I know that you believe that you understood what you think I said, but I am not sure you realize that what you heard is not what I meant."

http://www.cardomain.com/id/88delta88
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Thu Feb 24, 2005 12:52 pm 
TOC Admin
TOC Admin
User avatar

Joined: Fri Jun 06, 2003 3:58 pm
Posts: 3166
Images: 29
Location: Michigan, USA
88delta88 wrote:
make sure the ignition gives off 12V where it should when you turn the key to ON. This is likely the problem, check ALL of your fuses! The one fuse I'm thinking in particular is the ECM fuse. This would defiantely cause a total and instant dead car as you describe!


But it does turn over..... :?

TOC Admin
Brando



_________________
1999 Oldsmobile Intrigue GLS
1987 Oldsmobile Delta 88 Royale
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Thu Feb 24, 2005 5:41 pm 
TOC Village Idiot
TOC Village Idiot
User avatar

Joined: Mon Jun 09, 2003 5:06 pm
Posts: 2415
Images: 40
Location: Canada
Sorry... Should have clarified. The car might have power to the starter, but not to the ECM or to the coil pack. This would result in the situation he is seeing, but would not be the only cause for sure :-)



_________________
"I know that you believe that you understood what you think I said, but I am not sure you realize that what you heard is not what I meant."

http://www.cardomain.com/id/88delta88
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Thu Feb 24, 2005 5:50 pm 
TOC Member
TOC Member

Joined: Thu Aug 28, 2003 7:09 pm
Posts: 156
Images: 27
Location: Pocatello, Idaho
Is it just one of the wires has no sparks or all???

if it is all I would look at your ICM.



_________________
2001 Pontiac SSEi - 15.0 @93...pretty much stock
1998 Pontiac SSEi - 14.3 @95...3.2...FWI...nothing else
1993 Pontiac SSEi - 15.2 @90...2.3...CAI...nothing else
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Thu Feb 24, 2005 9:02 pm 
TOC Member
TOC Member

Joined: Fri Dec 10, 2004 6:08 am
Posts: 22
Location: Campbellsville, Ky
Checked ECM fuse with ohmeter and is fine.

Did not check all wires for spark.


Offline
 Profile  
 
 Post subject:
PostPosted: Fri Feb 25, 2005 9:48 am 
TOC Village Idiot
TOC Village Idiot
User avatar

Joined: Mon Jun 09, 2003 5:06 pm
Posts: 2415
Images: 40
Location: Canada
I wonder if it would be giving you a code right now because of all this. Do you know how to retirieve codes from your ECM?

If you've got a dead coil pack, the ECM might possibly be seeing this. Or at least give you a hint in the right direction?



_________________
"I know that you believe that you understood what you think I said, but I am not sure you realize that what you heard is not what I meant."

http://www.cardomain.com/id/88delta88
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Fri Feb 25, 2005 10:55 am 
TOC Member
TOC Member

Joined: Fri Dec 10, 2004 6:08 am
Posts: 22
Location: Campbellsville, Ky
I've got a Haynes manual on how to use the jumper wire method and it shows the codes.

I'm going to try that as soon as I get back to the car tomorrow night.


Offline
 Profile  
 
 Post subject:
PostPosted: Fri Feb 25, 2005 1:38 pm 
TOC Village Idiot
TOC Village Idiot
User avatar

Joined: Mon Jun 09, 2003 5:06 pm
Posts: 2415
Images: 40
Location: Canada
Sweet deal... Let us know how it goes.



_________________
"I know that you believe that you understood what you think I said, but I am not sure you realize that what you heard is not what I meant."

http://www.cardomain.com/id/88delta88
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Sun Feb 27, 2005 10:05 pm 
TOC Member
TOC Member

Joined: Fri Dec 10, 2004 6:08 am
Posts: 22
Location: Campbellsville, Ky
Ok, here's the trouble code I retrieved from the ECM:

Four flashes, pause, three flashes - Electronic Spark Control (ESC System)

Check wire leading to ECM terminal L Check the wiring connector at the ECS controller and at the ECM. Check wire from knock sensor to the ESC controller; if nessesary, reroute it away from other wires such as spark plug etc. Replace the knock sensor*

*Indicates component replacements may not cure the problem.


I was only at the car for five minutes when I did this test. I didn't get a chance to check as it described.

What do you guys think?


Offline
 Profile  
 
 Post subject:
PostPosted: Sun Feb 27, 2005 10:44 pm 
TOC Member
TOC Member

Joined: Fri Dec 10, 2004 6:08 am
Posts: 22
Location: Campbellsville, Ky
Oh and another thing, if a knock sensor is bad in a vehicle, would that make it not start?


Offline
 Profile  
 
 Post subject:
PostPosted: Sun Feb 27, 2005 11:59 pm 
TOC Admin
TOC Admin
User avatar

Joined: Fri Jun 06, 2003 3:58 pm
Posts: 3166
Images: 29
Location: Michigan, USA
I would suspect the Ignition Control Module to be faulty. Check ALL spark plugs for spark. If none of them spark, it must be the Ignition Control Module, as it's unlikely that all 3 coil packs are dead. With the code 43, the ECM will retard the spark timing by 10 degrees, but this very well may have been set because of the not starting issue. The knock sensor adjusts a 5 volt signal sent to the ECM, it will not prevent spark.

TOC Admin
Brando



_________________
1999 Oldsmobile Intrigue GLS
1987 Oldsmobile Delta 88 Royale
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Mon Feb 28, 2005 7:48 am 
TOC Member
TOC Member

Joined: Fri Dec 10, 2004 6:08 am
Posts: 22
Location: Campbellsville, Ky
If there are more plugs producing spark besides the one I checked, wouldn't it act like it wanted to start?

And is the ignition control module a common culprit of starting problems? How often do they go bad?

And if the trouble code 43 hasn't got anything to do with the car not starting, should I do like it said and replace the knock sensor anyway?

Thanks guys


Offline
 Profile  
 
 Post subject:
PostPosted: Mon Feb 28, 2005 9:20 am 
TOC Village Idiot
TOC Village Idiot
User avatar

Joined: Mon Jun 09, 2003 5:06 pm
Posts: 2415
Images: 40
Location: Canada
until you know for sure, maybe a used knock sensor is in order (no idea what they're worth)

Brando may be on to something, the ICM may not be functioning. This would produce no spark, because you dont have any instuctions for the coil packs. You didnt kick the wires under the dash when getting out of the car last did you? That might cause problems like this... Not saying that you're destructive or anything :-)



_________________
"I know that you believe that you understood what you think I said, but I am not sure you realize that what you heard is not what I meant."

http://www.cardomain.com/id/88delta88
Offline
 Profile Personal album  
 
 Post subject:
PostPosted: Mon Feb 28, 2005 10:39 am 
TOC Member
TOC Member

Joined: Fri Dec 10, 2004 6:08 am
Posts: 22
Location: Campbellsville, Ky
Kick the wires? Nope.


I think I'll put a new ignition module on it and a knock sensor and cross my fingers.


Offline
 Profile  
 
 Post subject:
PostPosted: Mon Feb 28, 2005 11:07 pm 
TOC Member
TOC Member
User avatar

Joined: Sun Feb 15, 2004 3:25 am
Posts: 3196
Images: 10
Location: Southern California
Hi Oldsmowbill, all,

Quote:
until you know for sure, maybe a used knock sensor is in order (no idea what they're worth)

You might want to find out what it does before you change it.

Quote:
Oh and another thing, if a knock sensor is bad in a vehicle, would that make it not start?

Hint: It's only used when the engine is running and under load.

You could make it a genuine learning experience if you did some research and found out what each part does before you decide to change it.
It's an excellent way of "learning the basics", it's how I learned.

Or you could just change everything at once and be done with it. :lol:

Regards, Norm



_________________
Harry S. Truman wrote:
When you have an efficient government, you have a dictatorship.
Offline
 Profile Personal album  
 
Display posts from previous:  Sort by  
 Page 2 of 4 [ 46 posts ]  Go to page Previous  1, 2, 3, 4  Next


All times are UTC - 5 hours


Who is online

Users browsing this forum: No registered users and 10 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to: